Wait until it finishes booting, log into web interface, set user/password, and set up DD-WRTĪny build past 16773 requires a different build, rather than e2k-e3k, for subsequent flashing.Power up and wait 5 minutes, then hard reset again.Wait AT LEAST 5 minutes until the WLAN light turn on, then unplug power on router and wait 30 seconds.Go to the Admin->Firmware Upgrade page and flash the downloaded file.Hard reset the router, then login to the router at 192.168.1.1.Download the desired e2k-e3k or e3000.bin trailed build.To flash another e2k-e3k build such as 15692 ( must have e2k-e3k in the file name), follow these steps.Do not flash directly from e2k-e3k to nv60k! To flash an nv60k build (that replaces e2k-e3k), you must flash a trailed E3000 build from svn16773 or later before nv60k.See Where do I download firmware? for links.If running an E3000.bin build since svn16772, you can upgrade using E3000 (trailed) or nv60k builds.For builds since svn16773, ONLY USE an E3000.bin trailed build.For builds before svn16773, ONLY USE e2k-e3k.bin builds.Clear your browser cache if the web login does not display.ĪFTER FLASHING THE TRAILED BUILD, only use the following builds OR YOU WILL BRICK THE e3000:.Wait 3 minutes and log into web interface.Plug E3000 back in and wait about 5 minutes until it finishes booting.Power cycle by unplugging E3000 for 30 secs.Wait AT LEAST 5 minutes until WLAN (Wireless LAN, not WAN) light turns on.Log into Web Interface and flash the firmware E3000 Initial Flash Trailed Build.Connect 1 Lan cable to pc doing the flash.As a precaution, USB disks should be removed before flashing.Disconnect all cables and wireless clients.Read all required reading sections of the Peacock announcement:.This guide also applies to units converted to an E3000, running Linksys firmware.Be aware that some E-series use nv60k, and others use nv64k. See Where do I download firmware? for links.Īlso reference this post regarding the newer nv60k.bin for Linksys E-series. 17.0dBm All ratesĥGHz output power per TX chain UNII-1 (5150-5250GHz) As factory lists it at a max of 20dBm, then a setting of 100mW could be used as 20dBm = 100mW, 17dBm = 50mW, and so on.Ģ.4GHz output power per TX chain 802.11b: Max. You can use these figures to come up with what Tx power would be best for you.

Download dd wrt v24 sp2